All content contained in this website is © R3W and GeeJay design. No content may be reproduced in any format without the prior written consent of the domain owners. All enquiries to be addressed to doc@r3w.co.uk Rocker Cover Gasket When replacing the rocker cover gasket clean the rocker cover and apply contact adhesive to  the lip where the gasket sits. This will make refitting the rocker cover much easier. And  don’t over tighten the nuts holding the rocker cover on or you will distort it and have an oil  leak again.      Easy SU carb idle adjustment Ever tried using a screwdriver to adjust the idle speed of your SU carb? Find a bit of old fuel line  about 3 inches long. Push fit this over the screw and you can easily twist the screw with two  fingers! Best part is you can leave the pipe on in case you need to adjust the idle speed later!       Cylinder Head Removal Tool     • Metal bar of suitable length • Width approx 1½” • Thickness at least ¼” • Holes spaced to suit head studs, slide fit over studs • nuts for head studs • plenty of washers or spacers Remove the Rocker shaft, place the plate on the studs, and using washers or spacers,build up the spacers  on the studs till there is just enough room to screw a nut on the studs.Tighten each nut evenly, and it will  push on the Cylinder Head studs, and free the head.